Set Switch Redundancy Mode - 3Com CoreBuilder 7000 Management Manual

Set Switch
Redundancy Mode
Table 13 Switch Redundancy Status Parameters
Parameter
Redundancy mode
Switch Engine Slot 1
Switch Engine Slot 2
I/F card for communication
Inter-Switch Communication status
Configuration status
Sets the switch redundancy mode of the CoreBuilder 7000 family ATM
switch.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Redundancy
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 13 2
The following prompt is displayed:
Description
Enhanced (version 4.5) or base (version 4.0)
Status of switch engine in specified slot:
active
redundant standby
redundant suspended
Slot number of interface card to be used for
communication
Established or not established
Synchronized or not synchronized
(1) SET: Switch setup
(13) SRS: Switch Redundancy setup
(2) SRM: Set switch redundancy mode
Format
0 - Enhanced
1 - Basic
1 1 13 2 [parameter]
The switch redundancy mode of the CoreBuilder 7000
family ATM switch is set.
Full redundancy mode invoked.
65
Switch Redundancy