3Com CoreBuilder 7000 Management Manual page 141

Auto Configuration is active on this port
|Parameter Name |Local Value
|================|================|================|=================
|ILMI Version |ILMI 4.0
|UNI Version |3.1
|NNI Sig Ver |PNNIV1.0
|Max Vpi Bits |3
|Max Vci Bits |9
|Max SVPC VPI |0
|Max SVCC VPI |7
|Min SVCC VCI |32
Example
The example below shows the results of auto-configuration of the NNI
version between the local switch and a peer switch. Initially, port 3.3 of
the local switch is configured to EIISP and the adjacent port, 4.3, of the
peer switch is configured to PNNI version 1.0. The result of the
auto-configuration is that the local switch is reconfigured to the lowest
common value: EIISP.
PNNI is available in version 4.5 extended only.
Display of Peer Switch
Enter:
1 1 8 6 1 4.3
The auto-configuration results at port 4.3 of the peer switch are displayed
as follows. It shows that the peer switch is configured to PNNIV1.0. (local
value) and the local switch (remote value) is configured to EIISP. The result
of the auto-configuration is that the peer switch is reconfigured to EIISP.
|Remote Value
|ILMI 4.0
|4.0
|EIISP
|3
|9
|0
|7
|32
ILMI Setup
|AutoCfg Result |
|ILMI 4.0 |
|3.1
|EIISP
|3
|9
|0
|7
|32
141
|
|
|
|
|
|
|