Enable/Disable Single-Ip Mode - 3Com CoreBuilder 7000 Management Manual

Enable/Disable Enables or disables the single-IP mode of the CoreBuilder 7000 family
Single-IP Mode ATM switch for the next reboot. When you select the multiple-IP option,
the single-IP mode is disabled. The factory default is single-IP disabled.
The options are:
For more information, see "Chassis Management — Single IP" on page
197 in the Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following mesage is displayed:
Single IP mode has changed to Multiple IP mode.
Multiple-IP mode is enabled.
1– Enable Single-IP
2– Disable Single-IP (Enable Multiple-IP)
Parameter
Single-IP select
1 1 2 8 2 2
Setting Up for Management
(1) SET: Switch setup
(2) MNG: Management setup
(8) SIS: Single IP setup
(2) SSI: Set & save Single IP Mode
Format or Range
1 to enable single-IP
2 to disable single-IP (multiple IP)
1 1 2 8 2 [parameters]
The single-IP mode is updated after the next reboot of
the switch.
Single IP mode has changed to
Single/Multiple IP mode.
85