Enable E-Iisp And Disable Pnni - 3Com CoreBuilder 7000 Management Manual

C 4: C
102
HAPTER ONFIGURING AND
Enable E-IISP and
Disable PNNI
M S
ANAGING THE WITCH
Changes the status of the routing mode to E-IISP and disables the PNNI
status. A change to the status takes place after the next reboot.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 3
The following message is displayed:
PNNI/E-IISP State is set to E-IISP for the next reboot.
PNNI/E-IISP routing mode was set to E-IISP for the next
reboot.
The status of the routing mode is set to PNNI for the next reboot.
M
ODULES
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(3) DIP: Enable E-IISP, disable PNNI
1 1 10 3
The PNNI/E-IISP state of the routing mode is set to
E-IISP and the value are displayed.
PNNI/E-IISP State is set to E-IISP for
the next reboot.
PNNI/E-IISP routing mode was set to
E=IISP for the next reboot.