3Com CoreBuilder 7000 Management Manual page 39

Entering the Menu Sequence
First, enter the menu sequence in the order shown in section A in
Figure 1 . In this example, the menu item numbers will be entered but
you can enter the three-letter mnemonic instead.
1 Enter at the Main Menu prompt.
1
The Platform Config Menu is displayed (the second screen in Figure 3),
followed by the path and the prompt:
(1)SYS>
2 Enter at the Platform Config Menu prompt.
1
The Switch Setup Menu submenu is displayed (the third screen in
Figure 3), followed by the path and the prompt:
(1)SYS\(1)SET>
3 Enter at the Switch Setup Menu prompt.
1
The Password Setup Menu is displayed as follows, followed by the path
and the prompt:
(1)SYS\(1)SET\(1)PAS>
These menu items are all configuration commands; none of them have
arrows to the right.
CB7000 switch module - Password Setup Menu:
(1) REA: Set Read-access Password
(2) WRI: Set Write-access Password
(3) ADM: Set Admin-access Password
[ '\' -Main,
(1)SYS\(1)SET\(1)PAS>1
4 Enter at the Password Setup Menu prompt.
1
The prompt for the new read password is displayed as follows:
Enter the new read password:
This completes the menu sequence.
Entering the Command Parameters
Now refer to section B in Figure 1 . This section explains which
parameters to enter and the format in which you enter them.
5 At the
Enter the new read password:
password in a format of up to eight alphanumeric characters.
'-' -Back in menus]
prompt, enter the new
The LMA Menu System 39