3Com CoreBuilder 7000 Management Manual page 182

C 7: C
182
HAPTER ONFIGURING
V C
IRTUAL HANNELS
Port Static PVC Connection Parameters
Table 28 shows the PVC connection parameters displayed by the LMA.
Table 28 Full UBR PVC Call Parameters
Name
Call Type
Cell Loss Level Discard
Priority
First CLP
First CLP
First Port ID
First VPI
First VCI
Second CLP (0,1,N)
Second Port ID
Second CLP
Second VPI
Second VCI
Example
Enter:
3 4 1 1 p2p 0 0 0 5.2 1 55 1 5.4 0 60
The following message is displayed:
A new PVC was created with call id:
Description
Whether the call defined is point-to-point (P2P) or
point-to-multipoint (P2M).
No default.
The level of congestion at which the system starts
discarding cells. The possible levels can be: no discard,
20%, 50% and 80%. In a point-to-multipoint call the
value is constant at 80%.
Default: 50%.
Whether the call cells are transferred through the switch
to the high priority queue or low priority queue.
Default: Low priority.
The discard policy for the cells of a call for the first (source)
point. The options are:
(0) Clear — Set all cells to be unmarked;
(1) Set — Set all cells to be marked for discarding;
(N) No change — leave all cells as they were when they
arrived at the port.
Default: (N) No change
The setting of the cell loss priority at the input port
The input port <slot.port>
The input port VPI value for the call
The input port VCI value for the call
The cell discard policy for the destination port
Default: (N) No change
The output port <slot.port>
The setting of the cell loss priority at the output port
The output port VPI value for the call
The output port VCI value for the call
11