Set Scope Mapping Table To Defaults - 3Com CoreBuilder 7000 Management Manual

C 13: C
438
HAPTER ONFIGURING AND
Set Scope Mapping
Table to Defaults
M PNNI (F
ANAGING
Example
Enter:
1 1 10 4 4 5 2 15 32
The following message is displayed:
PNNI Scope Mapping Table ROW new value
Index Name
15 pnniScopeGlobal
Press ENTER to continue...
The hierarchical level of pnniScopeGlobal is updated to 32.
Resets all the parameters of the scope mapping table to their default
values. A change to the scope mapping table parameters takes place
after the next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
Confirm reset
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 4 5 3
E V O
OR THE XTENDED ERSION
Pnni Level
32
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(5) SMT: Scope Mapping Table
(3) SST: Set Scope Mapping Table
Format or Range
y or n
1 1 10 4 4 5 3
The scope mapping table parameters are reset to their
default values as defined in the PNNI specification
af-pnni-0080_000.
PNNI Scope Mapping Table is set to
default values
)
NLY
Configuration
to defaults