Set Hello Inactivity Factor - 3Com CoreBuilder 7000 Management Manual

C 13: C
400
HAPTER ONFIGURING AND
Set Hello Inactivity
Factor
M PNNI (F
ANAGING
Sets the Hello inactivity factor. The Hello inactivity factor is the amount of
time (expressed in Hello intervals) after which the sending node will
consider a link to its neighbor down, if the neighbor does not respond.
For more information on Hello intervals, see "Set Hello Interval" on
page 399 . A change to the Hello inactivity factor takes place after the
next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
interval
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 4 4 10
The following message is displayed:
Default Value is 5, new value is 10
Press ENTER to continue...
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(4) INF: Hello Inactivity Factor
Format or Range
1 - 100 Hello intervals
1 1 10 4 3 4 4 [parameters]
The Hello inactivity factor is displayed and is updated
to its new value.
Default value is <x>, new value is <y>
)
NLY