Set Ctd Proportional Multiplier (%) - 3Com CoreBuilder 7000 Management Manual

C 13: C
408
HAPTER ONFIGURING AND
Set CTD Proportional
Multiplier (%)
M PNNI (F
ANAGING
Sets the CTD proportional multiplier percentage. The CTD proportional
multiplier percentage is a percentage of the last advertised Maximum Cell
Transfer Delay. A change to the CTD proportional multiplier percentage
value takes place after the next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
percentage
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 4 12 25
The following message is displayed:
Default Value is 50, new value is 25
Press ENTER to continue...
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(12) CTD: CTD Proportional
Format or Range
1 - 99%
1 1 10 4 3 4 12 [parameters]
The CTD proportional multiplier is displayed and is
updated to its new value.
Default value is <x>. New value is <y>
)
NLY
Multiplier(%)