Set Avcr Proportional Multiplier (%) - 3Com CoreBuilder 7000 Management Manual

Set AvCR Sets the AvCR (Available Capacity for Minimum Cell Rate) proportional
Proportional multiplier percentage. The AvCR proportional multiplier percentage is the
Multiplier (%) proportional multiplier used in the algorithms that determine significant
changes for AvCR parameters, expressed as a percentage. A change to
the AvCR proportional multiplier percentage takes place after the next
reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following message is displayed:
Default Value is 50, new value is 15
Press ENTER to continue...
Parameter
percentage
1 1 10 4 3 4 9 15
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(9) APM: AvCR Proportional
Multiplier(%)
Format or Range
1 - 99%
1 1 10 4 3 4 9 [parameters]
The AvCR proportional multiplier is displayed and is
updated to its new value.
Default value is <x>, new value is <y>
Setting the Timers 405