Efci Threshold; Display Efci Threshold - 3Com CoreBuilder 7000 Management Manual

C 4: C
98
HAPTER ONFIGURING AND

EFCI Threshold

Display EFCI
Threshold
M S
ANAGING THE WITCH
The following commands allow you to configure the EFCI threshold.

Display EFCI Threshold

Update EFCI Threshold
For more information about EFCI, see "Traffic Management" on page
135 in the Operations Guide.
The EFCI LMA commands are only relevant to the CoreBuilder 7000
switch. For the CoreBuilder 7000HD switch, the EFCI threshold mode is
not configurable and is always set to 50%.
Displays the EFCI Threshold of the CoreBuilder 7000 switch.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 7 1
The following message is displayed:
EFCI threshold mode is: 50% full.
M
ODULES
(1) SET: Switch setup
(7) FCI: EFCI threshold setup
(1) GET: Get EFCI threshold
1 1 7 1
The EFCI Threshold of the CoreBuilder 7000 family
ATM switch is displayed.
EFCI threshold mode is: n% full.