Update Default Gateway Address - 3Com CoreBuilder 7000 Management Manual

Update Default
Gateway Address
Updates the Default Gateway address of the CoreBuilder 7000 family
ATM switch. The default factory Default Gateway address is 0.0.0.0. The
default gateway address is updated after the next reboot of the switch.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Default gateway address valid IP address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 3 2 100.1.0.254
The Default Gateway address is updated to 100.1.0.254.
Setting Up for Management
(1) SET: Switch setup
(2) MNG: Management setup
(3) GWY: Default Gateway Setup
(2) SGW: Set & Save Default Gateway
Format or Range
1 1 2 3 2 [parameters]
The default gateway address is updated after the next
reboot of the switch.
Default gateway address was
successfully set.
75