Set Ubr Administrative Weight - 3Com CoreBuilder 7000 Management Manual

C 13: C
430
HAPTER ONFIGURING AND
Set UBR
Administrative
Weight
M PNNI (F
ANAGING
Sets the UBR Administrative Weight parameter. The UBR administrative
weight is the administrative weight of this interface port for the
unspecified bit rate service category.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
UBR admin weight
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 4 2 6 18000
The following message is displayed:
Default value is 5040, new value is set to 19000
Press ENTER to continue...
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(2) IPR: Interface Parameters
(6) UBW: UBR Admin Weight
Format or Range
1 - 2147483647
1 1 10 4 4 2 6 [parameters]
The UBR admin weight parameter is updated to its
new value.
Default Value is 5040, New value is set to <n>.
)
NLY