Configuring Virtual Channels; Display Call Routing; Display Call Routed To Atm Address - 3Com CoreBuilder 7000 Management Manual

7

Display Call Routing

Display Call Routed
to ATM Address
C
ONFIGURING
This chapter describes how to configure ATM virtual channels in the
®
CoreBuilder 7000 family ATM switch.
Display Call Routing
Display Virtual Channels at Port
Create Permanent Virtual Channel (PVC)
Example
Signaling Setup
Signaling Timers
Call Admission Control
Configuring VP Tunnels
The following command allows you to display call routing.
For information about routing, see "Routing — Internal Links" on page
125 in the Operations Guide.
Displays information for a call routed through a port to a specified ATM
address registered at the port. Use this command, for example, to get
information about a call routed through a specific port of the CoreBuilder
7000 family ATM switch to the ATM address of a specific LEC in a
SuperStack TM II Switch 2700 edge device attached to another port of the
CoreBuilder 7000 family ATM switch. Calls on both PVCs and SVCs can
be displayed by this command.
To specify the ATM address at a port: for a SVC, specify the member ID;
for a PVC, specify the port ID.
V C
IRTUAL HANNELS