Update Lecs-Address Access Status - 3Com CoreBuilder 7000 Management Manual

Update LECS-Address
Access Status
Updates the LECS-via-ILMI parameter for the specified port in the
CoreBuilder 7000 family ATM switch. If this parameter is enabled, the
LEC communicates on the channel VPI/VCI = (0/16) with the ILMI MIB.
The LEC submits an inquiry to obtain the LECS address. If this parameter
is disabled, the LEC retrieves the ATM address of the LECS via the
well-known address.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
LECS-via-ILMI
enable/disable
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 4 2 3.2
The following message is displayed:
LECS via ILMI is set to ENABLED
The LECS-via-ILMI status of port 2 in slot 3 is enabled.
(1) SET: Switch setup
(8) IME: ILMI setup
(4) MIB: ILMI MIB View setup
(2) SET: Set&save LECS via ILMI sta
Format or Range
slot.port
0 to disable LECS-via-ILMI
1 to enable LECS-via-ILMI
[parameters]
1 1 8 4 2
The LECS-via-ILMI status is updated for the selected
port immediately and is saved in flash.
LECS via ILMI is set to
ENABLED/DISABLED
1
ILMI Setup 135