3Com CoreBuilder 7000 Management Manual page 152

C 6: ILMI C
152
HAPTER ONFIGURATION
Command Actions
Enter the menu sequence: (3) CON: Connections
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Table 21 describes the IME parameters displayed by the command.
.
Table 21 IME Parameters
Name
Port ID
ATM address -
Network prefix
ATM address -
User part
Member ID
Example
Enter:
3 1 1 0.0
The following information is displayed. Note that ports <3.2>, <4.1> and
<6.7> have multiple ATM addresses registered.
(1) ADD: ATM addresses
(1) IME: IME addresses
Format or Range
slot.port (0.0 for all ports)
3 1 1 [parameters]
The IME addresses for the specified port are displayed.
Information is displayed as shown in the example
below.
Description
ATM port id.
Network prefix of ATM address
User part of ATM address
The member ID is made up of the port ID + a sequential number.
It provides a sequential numbering of ATM addresses registered
at a port. It is used to specify the SVC to the LEC with that ATM
address.