Display Node Address Information - 3Com CoreBuilder 7000 Management Manual

C 13: C
456
HAPTER ONFIGURING AND
Display Node Address
Information
M PNNI (F
ANAGING
Displays all ATM addresses that are used for route calculation of each
node about which information is stored in the topology database.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Node Address PTSE Table Parameters
For a full description of all the parameters displayed in the node address
information table, see Table 60: PTSE Table Parameters - Node Address
Section.
Example
Enter:
1 1 10 4 7 5
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(7) SHO: Show PNNI information
(5) ADD: Address PTSEs
1 1 10 4 7 5
The address information for each node in the
database is displayed.
Information is displayed as shown in the example.
)
NLY