Table of Contents
Advertisement
Configuring and Managing Time Parameters
97
Adding an NTP Server
To add an NTP server to the list of NTP servers, use the following
command:
set ntp server ip-addr
To configure a WX switch to use NTP server 192.168.1.5, type the
following command:
WX1200# set ntp server 192.168.1.5
Removing an NTP
To remove an NTP server, use the following command:
Server
clear ntp server {ip-addr | all}
If you use the all option, MSS clears all NTP servers configured on the
switch.
Changing the NTP
The default update interval is 64 seconds. To change the update interval,
Update Interval
use the following command:
set ntp update-interval seconds
You can specify an interval from 16 through 1024 seconds.
For example, to change the NTP update interval to 128 seconds, type the
following command:
WX1200# set ntp update-interval 128
success: change accepted.
Resetting the Update
To reset the update interval to the default value, use the following
Interval to the
command:
Default
clear ntp update-interval
Enabling the NTP
The NTP client is disabled by default. To enable the NTP client, use the
Client
following command:
set ntp {enable | disable}
Displaying NTP
To display NTP information, use the following command:
Information
display ntp
Here is an example:
WX1200> display ntp
Advertisement
Table of Contents
