Display Auto-Configuration Status - 3Com CoreBuilder 9000 User Manual

124 C 6: M
HAPTER ANAGING
Display
Auto-configuration
Status
N I
ETWORK NTERFACES
Display the auto-configuration status for the specified port of the
CoreBuilder 9000 ATM Enterprise Switch. Auto-configuration determines,
by negotiation, the User-Network Interface (UNI) parameters for the
specified port. The configuration options are enabled (auto-configured)
or disabled (not auto-configured).
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 2 1 3.1.2
The following message is displayed:
Auto-Configuration is ENABLED.
(1) SET: Switch Setup
(8) IME: ILMI Setup
(2) AUC: Auto-Configuration Setup
(1) GET: Get Auto-Configuration
ON/OFF Status
Format or Range
<slot.group.port>
1 1 8 2 1 [parameters]
The auto-configuration status for the specified port is
displayed.
Auto-Configuration is
<ENABLED/DISABLED>.