Table of Contents
Advertisement
80
C
4: C
HAPTER
ONFIGURING
Updating the Flash File
System
Resetting the Interface
Card
Viewing an Equipment
List
P
B
S330/S310 M
ATH
UILDER
ODULES
The flash file system contains system configuration information which is
automatically saved in flash memory at a predetermined interval. To update the
flash file system immediately, rather than at the next scheduled interval, follow
these steps:
1 From the System Administration menu, select [8] Update Flash File System. The
following prompt appears:
Do you want to update the flash file system (Y/N) [N]?
2 Enter y to update the flash file system.
CAUTION: The user configuration data is automatically saved into flash memory
every minute. If there is a system failure (for example. a power failure), any
changes that you make during the auto-saving interval will be lost. Thus, we
recommend that you use the [8] Update Flash File System option, as described
above, immediately after you make major configuration changes.
The PathBuilder S330/S310 software allows you to reset only the MCPU interface
card and the Voice Compression module (VCM) card. Resetting the MCPU reboots
the system. To reset the MCPU interface card or the VCM card, follow these steps:
If you reset the MCPU interface card, you will terminate your Telnet session.
1 From the System Administration menu, select [9] Reset Interface Card. You are
prompted to select the card you want to reset.
2 Enter the option corresponding to the card you want to reset (MCPU or VCM). The
following prompt appears:
Are you sure you want to reset this card (Y/N) [N]?
3 Enter y to reset the selected card.
To view information about the modules currently installed on your PathBuilder
S330/S310:
From the System Administration menu, select [10] Show Equipment List. Figure 49
shows a representative Equipment List.
Figure 49 Equipment List
, P
,
A
ORTS
AND
PPLICATIONS
Advertisement
Table of Contents
