Resetting The Interface Card; Viewing An Equipment List - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

Resetting the Interface
Card
Viewing an Equipment
List
2 Enter y to update the flash file system.
The user configuration data is automatically saved into flash memory every
minute. I there is a system failure (a power failure, for example), any changes that
you make during the auto-saving interval will be lost. Thus, we recommend that
you use the [12] Update Flash File System option, as described above, immediately
after you make major configuration changes.
To reset any PathBuilder S700 module, follow these steps:
If you reset the interface card, you will terminate your Telnet session.
1 From the System Administration menu, select [10] Reset Interface Card. The
following prompt appears:
Which slot to reset (1-18)?
2 Enter the number of the slot in which the card you want to reset is installed. The
following prompt appears:
Are you sure you want to reset this card (Y/N) [N]?
3 Enter y to reset the card.
To view information about the modules currently installed on your PathBuilder
S700:
From the System Administration menu, select [11] Show Equipment List. Figure 79
shows a sample Equipment List.
Figure 79 Equipment List
The Equipment List displays the following information for each installed module:
SLOT—A reference number for the ports on the motherboard. This number
corresponds to the number on the List Card menu. (See Figure 78, later in this
chapter.)
Viewing and Configuring System Information 115