Table of Contents
Advertisement
Resetting the Interface
Card
Viewing an Equipment
List
The PathBuilder S330/S310 software allows you to reset only the MCPU interface
card and the Voice Compression module (VCM) card. Resetting the MCPU reboots
the system.
To reset the MCPU interface card or the VCM card:
If you reset the MCPU interface card, you will terminate your Telnet session.
1 From the System Administration menu, select [8] Reset Interface Card. You are
prompted to select the card you want to reset.
2 Enter the option corresponding to the card you want to reset (MCPU or VCM). The
following prompt appears:
Are you sure you want to reset this card (Y/N) [N]?
3 Enter
to reset the selected card.
y
To view information about the modules currently installed in your shelf:
From the System Administration menu, select [9] Show Equipment List. Figure 58
shows a representative Equipment List.
Figure 58 Equipment List
The Equipment List displays the following information for each installed module:
Slot — Slot number. This is a reference number for the ports on the motherboard.
This number corresponds to the number on the List Card menu. (See Figure 60,
later in this chapter.)
Card type — The card type: Shelf, MCPU, CTX, T1/E1 UNI (4, or 8 if the optional
four-port IMA expansion module is installed), OC3/STM-1 UNI, SIM, Ethernet, CBR
T-1DSX, CBR E1, VOICE COMP (if the optional voice compression module is
installed), PCI ETHERNET (if the optional Ethernet 10/100 module is installed) or
DS3/E3 UNI (if the optional DS3 UNI or E3 UNI module is installed).
PART#-idprom — The part number as programmed at the factory.
PART#-oem — The part number for OEM customers.
Viewing and Configuring System Information
67
Advertisement
Table of Contents
