Rack Mounting - Cisco ISA500 Series Administration Manual

Getting Started
Installation
!
CAUTION
STEP 1
STEP 2
Cisco ISA500 Series Integrated Security Appliance Administration Guide

Rack Mounting

You can mount the security appliance in any standard size, 19-inch (about 48 cm)
wide rack. The security appliance requires 1 rack unit (RU) of space, which is 1.75
inches (44.45 mm) high.
Do not overload the power outlet or circuit when installing multiple devices in a
rack.
Place one of the supplied silicon rubber spacers on the side of the security
appliance so that the four holes align to the screw holes. Place the rack mount
bracket next to the silicon rubber spacer and install the M3 screws.
If the M3 screws are not long enough to reattach the bracket with the silicon
NOTE
rubber spacer, attach the bracket directly to the case without the silicon
rubber spacer.
Install the security appliance into a standard rack as shown below. Place the
washers on the brackets so that the holes align to the screw holes and then install
the M5 screws.
Step 1
Step 2
1
21