Required Tools; Slot Assignments - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Installation and Removal Instructions

Required Tools

Note
Warning

Slot Assignments

Note
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
8-6
You must have at least one supervisor engine running in the Catalyst 6500 series
switch with the IDSM-2. Refer to the Catalyst 6500 Series Switch Installation
Guide for more information.
You need the following tools to install the IDSM-2 in the Catalyst 6500 series
switches:
Flat-blade screwdriver
•
• Wrist strap or other grounding device
Antistatic mat or antistatic foam
•
Whenever you handle the IDSM-2, always use a wrist strap or other
grounding device to prevent serious damage from electrostatic discharge
(ESD). See Working in an ESD Environment, page
information.
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
The Catalyst 6006 and 6506 switch chassis each have six slots. The Catalyst 6009
and 6509 switch chassis each have nine slots. The Catalyst 6513 switch chassis
has 13 slots.
The Catalyst 6509-NEB switch has vertical slots numbered 1 to 9 from right to
left. Install the IDSM-2 with the component side facing to the right.
• You can install the IDSM-2 in any slot that is not used by the supervisor
engine.
• You can install up to eight IDSM-2s in a single chassis.
Chapter 8 Installing the IDSM-2
1-21, for more
78-15597-02