Chapter 17
DLPs H100 to H199
DLP-H106 Delete Ethernet RMON Alarm Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Double-click the Ethernet card where you want to delete the RMON alarm thresholds.
Step 1
In card view, click the Provisioning > Ether Ports > RMON Thresholds tabs or the Provisioning >
Step 2
POS Ports > RMON Thresholds tabs.
Click the RMON alarm threshold that you want to delete.
Step 3
Click Delete. The Delete Threshold dialog box appears.
Step 4
Click Yes to delete that threshold.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-H107 View Circuit Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate Cisco Transport Controller (CTC) view:
Step 1
•
•
•
Step 2
Click the Circuits tab. The Circuits tab has the following information:
Note
78-19416-01
This task deletes RMON threshold crossing alarms for Ethernet ports.
None
NTP-H68 Create or Delete Ethernet RMON Thresholds, page 7-5
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
This task provides information about ONS 15310-MA SDH circuits.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
To view circuits for an entire network, from the View menu, choose Go to Network View.
To view circuits that originate, terminate, or pass through a specific node, from the View menu,
choose Go to Other Node, then choose the node you want to search and click OK.
To view circuits that originate, terminate, or pass through a specific card, in node view, double-click
the card containing the circuits you want to view.
In node or card view, you can change the scope of the circuits that appear by choosing Card (in
card view), Node, or Network from the Scope drop-down list in the bottom right corner of the
Circuits window.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-9