Dlp-H85 Modify Alarm And Condition Filtering Parameters - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
If you want alarm filtering enabled when you view conditions, repeat Steps
Step 3
window.
Step 4 If you want alarm filtering enabled when you view alarm history, repeat Steps
window.
Step 5 Return to your originating procedure (NTP).

DLP-H85 Modify Alarm and Condition Filtering Parameters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At the node, network, or card view, click the Alarms tab, Conditions tab, or History tab.
Step 1
Click the Filter command button at the lower-left of the bottom toolbar.
Step 2
The filter dialog box appears, displaying the General tab.
box; the Conditions and History tabs have similar dialog boxes.
Figure 16-23
In the General tab Show Severity box, you can choose which alarm severities will show through the
alarm filter and provision a time period during which filtered alarms show through the filter. To change
the alarm severities shown in the filter, go to
to Step
78-19416-01
This task changes alarm and condition reporting in all network nodes.
None
DLP-H84 Enable Alarm Filtering, page 16-102
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
Alarm Filter Dialog Box General Tab
4.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Figure 16-23
Step 3. To change the time period filter for the alarms go
1 and 2 using the Conditions
1 and 2 using the History
shows the Alarm Filter dialog
16-103