Dlp-B155 Delete A Protection Group; Ntp-B204 Delete A Sonet Dcc Termination - Cisco ONS 15327 Procedure Manual

NTP-B204 Delete a SONET DCC Termination

DLP-B155 Delete a Protection Group

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In the node view, click the Provisioning > Protection tabs.
In the Protection Groups list, click the protection group you want to delete.
Step 2
Click Delete.
Step 3
Click Yes in the Delete Protection Group dialog box to confirm deletion. Confirm that the changes
Step 4
appear; if they do not, repeat Steps
Return to your originating procedure (NTP).
Step 5
NTP-B204 Delete a SONET DCC Termination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Deleting a DCC termination can cause you to lose visibility of nodes that do not have other DCCs or
network connections to the CTC computer.
Complete the
Step 1
Step 2.
Step 2 In node view, click the Provisioning > SONET DCC tabs.
Click the DCC termination you want to delete. Click Delete. The Delete SDCC Termination dialog box
Step 3
opens.
Select the Set Port Out of Service check box, as needed, if you want to change the OC-N port where
Step 4
the DCC terminated to out of service (this may be service affecting).
Click Yes to confirm. Confirm that the changes appear.
Step 5
Stop. You have completed this procedure.
Cisco ONS 15327 Procedure Guide, R4.0
9-14
Use this task to delete a 1+1 protection group.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
1 through 3.
Use this task to delete a SONET DCC termination on the ONS 15327.
None
DLP-B253 Provision SONET DCC Terminations, page 4-5
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page
Chapter 9
2-23. If you are already logged in, continue with
Change Node Settings
March 2003