Dlp-B260 Set Auto-Refresh Interval For Displayed Pm Counts - Cisco ONS 15327 Procedure Manual

NTP-B195 Monitor Electrical or Optical Performance
In node view, double-click an Ethernet card, XTC card (for electrical PM counts), or OC-N card. The
Step 1
card view appears.
Click the Performance tab.
Step 2
Click Clear.
Step 3
From the Clear Statistics menu, choose one of three options:
Step 4
•
•
•
From the Clear Statistics menu, click Yes to clear the selected statistics.
Step 5
View the displayed columns to verify that the selected PM counts have been cleared.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-B260 Set Auto-Refresh Interval for Displayed PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click an Ethernet card, XTC card (for electrical PM counts), or OC-N card. The
Step 1
card view appears.
Click the Performance tab.
Step 2
Click the Auto-refresh drop-down menu button.
Step 3
Choose one of six options:
Step 4
•
•
•
•
•
•
Cisco ONS 15327 Procedure Guide, R4.0
7-12
Selected statistics: Clearing selected statistics erases from the card and the window display all PM
counts associated with the current combination of statistics on the selected port. This means the
selected time interval, direction, and signal type counts are erased from the card and the window
display.
All statistics on port x: Clearing all statistics on port x erases from the card and the window display
all PM counts associated with all combinations of the statistics on the selected port. This means all
time intervals, directions, and signal type counts are erased from the card and the window display.
All statistics in current view: Clearing all statistics in the current view erases from the card and the
window display all PM counts for all ports.
None: This option disables the auto-refresh feature.
15 Seconds: This option sets the window auto-refresh to 15-second time intervals.
30 Seconds: This option sets the window auto-refresh to 30-second time intervals.
1 Minute: This option sets the window auto-refresh to 1-minute time intervals.
3 Minutes: This option sets the window auto-refresh to 3-minute time intervals.
5 Minutes: This option sets the window auto-refresh to 5-minute time intervals.
This task changes the window auto-refresh intervals for updating the
displayed PM counts.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
Chapter 7 Monitor Performance
March 2003