Dlp-H33 Delete A Node From The Current Session Or Login Group - Cisco ONS 15310-MA SDH Procedure Manual

Required/As Needed
Onsite/Remote
Security Level
From the CTC File menu, click Add Node.
Step 1
In the Add Node dialog box, enter the node name (or IP address).
Step 2
If you want to add the node to the current login group, check Add node to current login group.
Step 3
Otherwise, leave it unchecked.
Note
Click OK.
Step 4
After a few seconds, the new node appears on the network view map.
Return to your originating procedure (NTP).
Step 5

DLP-H33 Delete a Node from the Current Session or Login Group

Purpose
Tools
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the node that you want to delete.
Step 2
From the CTC File menu, click Delete Selected Node.
Step 3
After a few seconds, the node disappears from the network view map.
Return to your originating procedure (NTP).
Step 4
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-48
As needed
Onsite or remote
Provisioning or higher
This check box is active only if you selected a login group when you logged into CTC.
This task removes a node from the current CTC session or login node
group. To remove a node from a specified login node group, see the
"DLP-H34 Delete a Node from a Specified Login Node Group" task on
page 16-49.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 16 DLPs H1 to H99
78-19416-01