Ntp-B142 Create An E-Series Shared Packet Ring Ethernet Circuit - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels
c.
Click Next.
Step 10
Provision the circuit destination:
Step 11
a.
b.
c.
Step 12 Click Next. The Circuits window appears.
Step 13 Confirm that the following circuit information is correct:
•
•
•
•
Click Finish.
Step 14
Complete the
Step 15
Stop. You have completed this procedure.
NTP-B142 Create an E-Series Shared Packet Ring Ethernet
Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
create the circuit. If you are already logged in, continue with
If a high number of VLANs is already used by the network, complete the
Step 2
Available VLANs" task on page 5-68
create a VLAN during each circuit creation task).
Verify that the Ethernet cards that will carry the circuit are provisioned for multi-card EtherSwitch
Step 3
Group. See the
Provision and enable the Ethernet ports. See
Step 4
page
March 2003
From the Port drop-down menu choose a port.
From the Node drop-down menu choose the circuit destination node.
From the Slot drop-down menu choose the slot containing the E-Series card that you will use for
other end of the point-to-point circuit.
From the Port drop-down menu choose a port.
Circuit name
Circuit type
Circuit size
ONS 15327 circuit nodes
"NTP-B146 Test E-Series Circuits" procedure on page
This procedure creates a shared packet ring Ethernet circuit. It does not
apply to E-Series cards in port-mapped mode.
E-Series Ethernet cards must be installed at both Ethernet circuit endpoint
nodes.
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"DLP-B246 Provision E-Series Ethernet Card Mode" task on page
5-69.

NTP-B142 Create an E-Series Shared Packet Ring Ethernet Circuit

at a node on the network where you will
Step
to verify that sufficient VLAN capacity is available (you will
"DLP-B220 Provision E-Series Ethernet Ports" task on
Cisco ONS 15327 Procedure Guide, R4.0
5-72.
2.
"DLP-B99 Determine
5-69.
5-57