Ntp-B190 Create A Unidirectional Optical Circuit With Multiple Drops - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels
•
•
If you selected Fully Protected Path and the circuit will be routed on a path protection dual ring
Step 11
interconnect (DRI), check the Dual Ring Interconnect check box.
Click Next. In the Route Review and Edit area, node icons appear for you to route the circuit manually.
Step 12
Complete the
Step 13
Click Finish. If the path does not meet the specified path diversity requirement, CTC displays an error
Step 14
message and allows you to change the circuit path. If you entered more than 1 in Number of circuits, the
Circuit Creation dialog box appears after the circuit is created for you to create the remaining circuits.
Repeat Steps
Step 15
When all the circuits are created, CTC displays the main Circuits window. Verify that the circuit(s) you
Step 16
created appear in the window.
Complete the
Step 17
Stop. You have completed this procedure.
NTP-B190 Create a Unidirectional Optical Circuit with Multiple
Drops
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the tunnel source and destination ports before you create the circuit,
Step 2
complete the
From the View menu choose Go to Network View.
Step 3
Click the Circuits tab, then click Create.
Step 4
In the Circuit Creation dialog box, complete the following fields:
Step 5
•
•
March 2003
Nodal Diversity Desired—Specifies that node diversity is preferred, but if node diversity is not
possible, CTC creates fiber-diverse paths for the path protection portion of the complete circuit path.
Link Diversity Only—Specifies that only fiber-diverse primary and alternate paths for path
protection portions of the complete circuit path are needed. The paths may be node-diverse, but CTC
does not check for node diversity.
"DLP-B98 Provision an Optical Circuit Route" task on page
4 through 14 for each additional circuit.
"NTP-B62 Test Optical Circuits" procedure on page
This procedure creates a unidirectional OC-N circuit with multiple traffic
drops (circuit destinations)
None
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"DLP-B314 Assign a Name to a Port" task on page
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Type—Choose STS.

NTP-B190 Create a Unidirectional Optical Circuit with Multiple Drops

5-51.
at a node on the network where you will
Step 2.
5-16. If not, continue with
Cisco ONS 15327 Procedure Guide, R4.0
5-49.
Step 3.
5-45