Configuring The System For Remote Access - Cisco ASR 5000 Administration Manual

Configuring the System for Remote Access

If you are executing this command to correct an address or subnet that was mis-configured with the Quick Setup
Wizard, you must verify the default route and port binding configuration. Use step 11 and step 6 of this procedure.
If there are issues, perform steps 7e through 7k to reconfigure the information.
d) Enter the following command to exit the Ethernet interface configuration mode:
host_name
[local]
host_name
[local]
e) Configure a static route, if required, to point the system to a default gateway. Entering the following command:
{ ip | ipv6 } route gw_address interface_name
f) Enter the following to exit from the context configuration mode:
host_name
[local]
host_name
[local]
g) Enter the Ethernet Port Configuration mode:
host_name
[local]
h) Bind the port to the interface that you created in step 7b. Binding associates the port and all of its settings to the
interface. Enter the following command:
host_name
[local]
host_name
[local]
interface_name is the name of the interface that you configured in step 7b.
i) Specify which Ethernet media you are using. Enter the following:
host_name
[local]
The SPIO is equipped with dual RJ-45 and dual SFP interfaces. The RJ-45 interfaces connect the system to the
management network with CAT3 or CAT5 Ethernet cable. The SFP interfaces connect the system to the management
network with 1000Base-SX optical fiber cable.
j) Configure the port speed, if needed, by entering the following command:
medium { auto | speed { 10 | 100 | 1000 | 10000 } duplex { full | half } }
k) Exit the Ethernet Interface Configuration mode by entering the command:
host_name
[local]
host_name
[local]
Important
Configuring the System for Remote Access
Configure the system for remote access. An administrative user may access the system from a remote location
over a local area network (LAN) or wide area network (WAN):
• Telnet
• Secure Shell (SSH)
• File Transfer Protocol (FTP) (secured or unsecured)
• Trivial File Transfer Protocol (TFTP)
ASR 5000 System Administration Guide, StarOS Release 21.1
24
exit
(config-if-eth)#
(config-ctx)#
exit
(config-ctx)#
(config)#
port ethernet slot#
(config)#
(config-port-slot#/port#)#
(config-port-slot#/port#)#
(config-port-slot#/port#)#
(config-port-slot#/port#)#
(config)#
See below for instructions on configuring the SPIO management interface with a second IP address.
port#
/
bind interface interface_name local
no shutdown
media [ rj45 | sfp ]
exit
Getting Started