Malfunction Indicator Lamp - SSANGYONG MUSSO Owner's Manual

MALFUNCTION INDICATOR LAMP

Illuminates briefly as you turn the ignition ON,
before you start the engine.
This means that the indicator bulb is operat-
ing, properly.
The lamp should go out after the engine is
started.
100 120
140
H F 80
160
60
180
0 0 0 0 0 0
40
C E 200
20
0 0 0 0
0 220
km / h
BRAKE
TCS
EBD P R N
D 3 2 1
Do not drive with the malfunction
indicator lamp on.
The indicator lamp signals that your
vehicle has a problem that requires
attention.
Driving with the malfunction indica-
tor lamp on can damage the emis-
sions control system and can affect
the fuel economy and drivability or
your vehicle.
Consult a Ssangyong distributor or
a Ssangyong Authorized Service
Operation to repair the problem as
soon as possible.
3
2
4
1
0
5
x1000rpm
ECS 4WD 4WD 4WD
SPORT CHECK HIGH LOW
CAUTION
INSTRUMENTS AND CONTROLS 3–9
Your vehicle was designed in compliance
with European On Board Diagnostic (EOBD)
requirements which were specified by Eu-
ropean Economic Community Directive.
The Malfunction Indictor Lamp (MIL) will illu-
minate if a fault exists in the emission re-
lated components or related sub systems.
It will stay on as long as the Engine Control
Unit (ECU) detects the fault.
If a severe misfire is detected, fuel is cut
automatically to avoid catalytic converter
damage.
Your vehicle's electronic system will switch
to an emergency running program so you
may continue to drive.
However, you should consult a Ssangyong
Distributor or Ssangyong Authorized Service
Operation to repair the problem as soon as
possible.
If your vehicle is equipped with an automatic
transmission, see "Emergency Shifting Pro-
cedure" on page 2-10.