Clear Ip Bgp Peer-Group - Dell C9000 Series Reference Manual

clear ip bgp peer-group

Reset a peer-group's BGP sessions.
C9000 Series
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4
[multicast | unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name
peer-group-name
ipv4 multicast
ipv4 unicast
ipv6 unicast
soft
in
out
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.4.(0.0)
8.3.19.0
Enter the keyword vrf and then the name of the VRF to reset
the peer group corresponding to that VRF.
NOTE: You can use this attribute on a specific VRF to
remove history routes corresponding to that VRF. You
can also use this attribute to return the suppressed
routes corresponding to a specific VRF to an active state.
Enter the peer group name to reset the BGP sessions within that
peer group.
(OPTIONAL) Enter the keyword ipv4 followed by the keyword
multicast to reset ipv4 multicast routes.
(OPTIONAL) Enter the keyword ipv4 followed by the keyword
unicast to reset ipv4 unicast routes.
(OPTIONAL) Enter the keyword ipv6 followed by the keyword
unicast to reset ipv6 unicast routes.
(OPTIONAL) Enter the keyword soft to reset soft configuration.
Enter the keyword in to re-configure soft inbound updates.
Enter the keyword out to re-configure soft outbound updates.
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Added the ipv4 multicast and ipv6 unicast parameters.
Added support for VRF.
Introduced on the S4820T.
Border Gateway Protocol 447