Dell C9000 Series Reference Manual page 512

Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.4.(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information The show ip bgp community-list command without any parameters lists BGP
routes matching the Community List and the output is the same as for the show ip
bgp command output.
The following describes the show ip bgp community-list pass command shown
in the following example.
Field
Network
Next Hop
Metric
LocPrf
Weight
Path
Example
Dell#conf t
Dell(conf)#ip community-list cl1
Dell(config-community-list)#permit 1000:1
Dell(config-community-list)#end
Dell#show ip bgp community-list cl1
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r
- redistributed
Origin codes: i - IGP, e - EGP, ? - incomplete
Weight Path
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Added ipv4 multicast and ipv6 unicast parameters.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the destination network prefix of each BGP route.
Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing table.
Displays the BGP route's metric, if assigned.
Displays the BGP LOCAL_PREF attribute for the route.
Displays the route's weight.
Lists all the ASs the route passed through to reach the
destination network.
n - network,
Network
D - denied, S - stale
Next Hop Metric LocPrf
Border Gateway Protocol 512