Bgp Client-To-Client Reflection - Dell C9000 Series Reference Manual

Version
8.3.1.0
Usage Information Configuring this option retains the current best-path. When sessions are then reset, the
oldest received path is chosen as the best-path.

bgp client-to-client reflection

Allows you to enable route reflection between clients in a cluster.
C9000 Series
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client
reflection command.
Defaults Enabled when a route reflector is configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information Route reflection to clients is not necessary if all client routers are fully meshed.
Related
bgp cluster-id
Commands
neighbor route-reflector-client
Description
Introduced
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— assigns an ID to a BGP cluster with two or more route reflectors.
— configures a route reflector and clients.
Border Gateway Protocol 422