neighbor distribute-list
Distribute BGP information via an established prefix list.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-
list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ip-address | peer-
group-name} distribute-list prefix-list-name {in | out} command.
Parameters
ip-address
peer-group-name
prefix-list-name
in
out
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Enter the IP address of the neighbor in dotted decimal format.
Enter the name of the peer group to apply the distribute list filter
to all routers in the peer group.
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow
all routes).
Enter the keyword in to distribute only inbound traffic.
Enter the keyword out to distribute only outbound traffic.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol
468