Neighbor Soft-Reconfiguration Inbound - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information Peers that are enabled within a peer group are disabled when their peer group is
disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor
or BGP peer group. Use this command with caution as it terminates the specified BGP
sessions. When a neighbor or peer group is shut down, use the show ip bgp
summary command to confirm its status.
Related
show ip bgp summary
Commands
show ip bgp neighbors

neighbor soft-reconfiguration inbound

Enable soft-reconfiguration for BGP.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration
inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-
reconfiguration inbound command.
Parameters
ip-address
peer-group-name
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— displays the current BGP configuration.
— displays the current BGP neighbors.
Enter the IP address of the neighbor in dotted decimal format.
Enter the name of the peer group to disable or enable all routers
within the peer group.
Border Gateway Protocol 488