Capture Bgp-Pdu Neighbor - Dell C9000 Series Reference Manual

capture bgp-pdu neighbor

Enable capture of an IPv4 BGP neighbor packet.
C9000 Series
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx | tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu
neighbor ipv4-address command.
Parameters
ipv4-address
direction {both |
rx | tx}
Defaults Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.5.1.0
Related
capture bgp-pdu max-buffer-size
Commands
show capture bgp-pdu neighbor
Enter the IPv4 address of the target BGP neighbor.
Enter the keyword direction and a direction — either rx for
inbound, tx for outbound, or both.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
— specifies a size for the capture buffer.
— displays BGP packet capture information.
Border Gateway Protocol 440