Debug Ip Bgp Events - Dell C9000 Series Reference Manual

Version
7.6.1.0

debug ip bgp events

Display information on local BGP state changes and other BGP events.
C9000 Series
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] events [in | out]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D |
X:X:X:X::X | peer-group peer-group-name] events [in | out]
command.
Parameters
vrf vrf-name
A.B.C.D
X:X:X:X::X
peer-group peer-
group-name
in
out
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.0.2.0
8.3.19.0
Description
Introduced IPv6 MGBP support for the E-Series.
(OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to display BGP state changes corresponding to that VRF.
(OPTIONAL) Enter the IPv4 address of the neighbor.
(OPTIONAL) Enter an IPv6 address.
(OPTIONAL) Enter the keyword peer-group then the name of
the peer group.
(OPTIONAL) Enter the keyword in to view only events on
inbound BGP messages.
(OPTIONAL) Enter the keyword out to view only events on
outbound BGP messages.
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Introduced on the S6000–ON.
Introduced on the S6000.
Introduced on the S4820T.
Border Gateway Protocol 451