Dell C9000 Series Reference Manual page 456

Parameters
vrf vrf-name
A.B.C.D
X:X:X:X::X
peer-group peer-
group-name
in
out
prefix-list prefix-
list-name
ip-address
peer-group-name
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
(OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to view BGP updates information corresponding to that
VRF.
(OPTIONAL) Enter an IPv4 address of the neighbor.
(OPTIONAL) Enter an IPv6 address.
(OPTIONAL) Enter the keyword peer-group followed by the
name of the peer group.
(OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
(OPTIONAL) Enter the keyword out to view only BGP updates
sent to neighbors.
(OPTIONAL) Enter the keyword prefix-list then the name of
an established prefix list. If the prefix list is not configured, the
default is permit (to allow all routes).
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group.
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol 456