Log-Adjacency-Changes; Lsp-Gen-Interval - Dell Z9500 Reference Manual

If you are configuring only one area in your network, you do not need to run both
Level 1 and Level 2 routing algorithms. You can configure the IS type as Level 1.

log-adjacency-changes

Generate a log messages for adjacency state changes.
Z9500
Syntax
log-adjacency-changes
To disable this function, use the no log-adjacency-changes command.
Defaults Adjacency changes are not logged.
Command ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
Usage This command allows you to monitor adjacency state changes, which are useful
Information when you monitor large networks. Messages are logged in the system's error
message facility.

lsp-gen-interval

Set the minimum interval between successive generations of link-state packets (LSPs).
Z9500
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
Intermediate System to Intermediate System (IS-IS)
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
1063