Receiver On-Vehicle Inspection; Receiver Removal And Installation - Toyota Hilux Surf 1993 Owner's Manual

AIR CONDITIONING SYSTEM
RECEIVER
(See page AC–7)
ON–VEHICLE INSPECTION
CHECK SIGHT GLASS, FUSIBLE PLUG AND FITTINGS FOR
LEAKAGE
Use a gas leak tester. Repair as necessary.
REMOVAL OF RECEIVER
1. RECOVER REFRIGERANT FROM REFRIGERATION SYS–
TEM
2. DISCONNECT TWO LIQUID TUBES FROM RECEIVER
HINT: Cap the open fittings immediately to keep mois–
ture out of the system.
3. REMOVE RECEIVER FROM RECEIVER HOLDER
INSTALLATION OF RECEIVER
1. INSTALL RECEIVER IN RECEIVER HOLDER
HINT: Do not remove the caps until ready for connec–
tion.
2. CONNECT TWO LIQUID TUBES TO RECEIVER
Torque: 5.4 N" m (55 kgf" cm, 43 in." Ibf)
3. IF RECEIVER WAS REPLACED, ADD COMPRESSOR OIL
TO COMPRESSOR
Add 20 cc (0.7 fl. oz.)
Compressor oil: ND OIL6,
4. EVACUATE AIR FROM AIR CONDITIONING SYSTEM
5. CHARGE AIR CONDITIONING SYSTEM WITH
REFRIGERANT AND CHECK FOR GAS LEAKAGE
Specified amount: 700 – 800 g (1.5 – 1.8 Ib)
– Receiver
SUNISO No.5GS or equivalent
AC–23