SIP Media Gateway commands
[no]
Example
AG/configure/voice-port (7/2/1)# signal ground-start
configure voice-port supervisory-disconnect
Use this command to enable a supervisory disconnect signal on an FXO port in loop-start mode
or an FXS DID port.
Supervisory disconnect signaling is a power denial from the switch lasting at least 350 ms.
When this condition is detected, the system interprets this as a disconnect indication from the
switch and clears the call.
When disconnect supervision is enabled in conjunction with answer supervision, disconnect
supervision is detected by battery reversal.
Supervisory disconnect signaling is enabled by default.
Syntax
[no] supervisory-disconnect
Table 404: Variable definitions
[no]
Example
AG/configure/voice-port (7/2/1)# no supervisory-disconnect
Common FXS and T1 CAS command
configure voice-port timeouts interdigit
Use this command to configure the interdigit timeout value for a specified FXS or T1 CAS voice
port.
366
Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Sets signaling to the default value: loop-
start.
Value
Disables the supervisory disconnect
signaling.
August 2013