Bgp Default Local-Preference; Bgp Enforce-First-As - Dell Force10 S4810P Reference Manual

Related show ip bgp dampened-paths
Commands

bgp default local-preference

Change the default local preference value for routes exchanged between internal BGP peers.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Parameters
value
Defaults 100
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The bgp default local-preference command setting is applied by all routers within
Information
the AS. To set the local preference for a specific route, use the set local-preference
command in ROUTE-MAP mode.
Related set local-preference
Commands

bgp enforce-first-as

Disable (or enable) enforce-first-as check for updates received from EBGP peers.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax bgp enforce-first-as
To turn off the default, use the no bgp enforce-first-as command.
Defaults Enabled
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
362
– views the BGP paths.
Enter a number to assign to routes as the degree of preference for
those routes. When routes are compared, the higher the degree of
preference or local preference value, the more the route is preferred.
The range is 0 to 4294967295. The default is 100.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
– assigns a local preference value for a specific route.
Introduced on the Z9000.
Introduced on the S4810.