Show The Running-Configuration For An Interface; Clear Ipv6 Routes - Dell Force10 Z9000 Configuration Manual

Show the Running-Configuration for an Interface

View the configuration for any interface with the following command.
Command Syntax
show running-config
interface
type {slot/port}
Figure 21-11
Figure 21-11. Command Example:
FTOS#show run int gi 2/2
!
interface GigabitEthernet 2/2
no ip address
ipv6 address 3:4:5:6::8/24
shutdown
FTOS#

Clear IPv6 Routes

Use the clear IPv6 route command to clear routes from the IPv6 routing table.
Command Syntax
clear ipv6 route
}
prefix-length
| IPv6 Routing
466
Command Mode
EXEC
show running-config
illustrates the
*
{ |
ipv6 address
Purpose
Show the currently running configuration for the
specified interface
Enter the keyword
interface and slot/port information:
•
•
•
•
•
command output. Note the IPv6 address listed.
show running-config interface
Command Mode Purpose
EXEC Clear (refresh) all or a specific routes from the IPv6
routing table.
: all routes
*
ipv6 address
mask
interface followed by the type of
For a 10/100/1000 Ethernet interface, enter the
keyword followed by the slot/
GigabitEthernet
port information.
For a Gigabit Ethernet interface, enter the
keyword followed by the slot/
GigabitEthernet
port information.
For the Management interface on the RPM, enter
the keyword
ManagementEthernet
the slot/port information.
For a 10 Gigabit Ethernet interface, enter the
keyword TenGigabitEthernet
slot/port information.
For a 40-Gigabit Ethernet interface, enter the
keyword fortyGigE followed by the slot/port
information.
: x:x:x:x::x
: prefix length 0-128
followed by
followed by the