Ip Helper-Address - Dell Z9500 Reference Manual

Usage
You can only configure one domain name with the ip domain-name command.
Information
To configure more than one domain name, configure the ip domain-list
command up to six times.
To enable dynamic resolution of hosts, use the following steps:
•
•
To view current bindings, use the show hosts command.
Related
ip domain-list
Commands

ip helper-address

Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the
DHCP server is not on the same subnet as the client.
Z9500
Syntax
ip helper-address ip-address
To remove a DHCP server address, use the no ip helper-address command.
Parameters
ip-address
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
914
specify a domain name server with the ip name-server command
enable DNS with the ip domain-lookup command
— configures additional names.
Enter an IP address in dotted decimal format (A.B.C.D).
Description
Introduced on the Z9500.
Added support for IPv6.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
IPv4 Routing