Ip Router Isis - Dell S6000 Reference Manual

Command ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Usage IS-IS normally purges LSPs with an incorrect data link checksum causing the LSP
Information source to regenerate the message. A cycle of purging and regenerating LSPs can
occur when a network link continues to deliver accurate LSPs even though there is
a link causing data corruption. This process could cause disruption to your system
operation.

ip router isis

Configure IS-IS routing processes on an interface and attach an area tag name to the routing process.
S6000
Syntax
ip router isis [tag]
To disable IS-IS on an interface, use the no ip router isis [tag] command.
Parameters
tag
Defaults No processes are configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Intermediate System to Intermediate System (IS-IS)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
(OPTIONAL) The tag you specify identifies a specific area
routing process. If you do not specify a tag, a null tag is
assigned.
Introduced on the S6000.
813