Table of Contents
Advertisement
Step 1: Unpack and Inspect the Module
The module is shipped in materials which prevent damage from static. The module should only be
removed from the packaging in an anti-static area ensuring that correct anti-static precautions are taken. Store all
modules in anti-static envelopes when not in use.
Electrostatic Discharge (ESD) Precautions
Inspect for Damage
After unpacking a module, inspect it for any shipping damage. Report any damage to the shipping agent
immediately, as such damage is not covered by the warranty (see warranty information at beginning of this
document).
To avoid damage when handling a module, do not touch any exposed components or connector pins.
See
www.agilent.com/find/tips
Return a Module for Service
Should it become necessary to return a module for repair or service, follow the steps below:
1. Review the warranty information shipped with your product.
2. Contact Agilent to obtain a Return Material Authorization (RMA) and return address. For assistance finding
Agilent contact information, go to
service) or refer to the "Support" information on the product web page at
3. Write the following information on a tag and attach it to the malfunctioning equipment:
Name and address of owner. A P.O. box is not acceptable as a return address.
l
Product model number (for example, U5303A).
l
Agilent U5303A Startup Guide
Electrostatic discharge (ESD) can damage or destroy
electronic components. Use a static-safe work station to
perform all work on electronic assemblies. The figure (left)
shows a static-safe work station using two types of ESD
protection: conductive table-mat and wrist-strap
combination, and conductive floor-mat and heel-strap
combination. Both types, when used together, provide a
significant level of ESD protection. Of the two, only the
table-mat and wrist-strap combination provides adequate
ESD protection when used alone. To ensure user safety, the
static-safe accessories must provide at least 1 MΩ of
isolation from ground.
safe work station when working on circuitry with a
voltage potential greater than 500 volts.
for information on preventing damage to your Agilent equipment.
www.agilent.com/find/assist
Step 1: Unpack and Inspect the Module
DO NOT use these techniques for a static-
(worldwide contact information for repair and
www.agilent.com/find/U5303A
9
Advertisement
Table of Contents
