Table of Contents
Advertisement
Power Meter
Chapter 13
After changing any settings in the Quick Setup dialog press OK or
return to the Fiber Length and Delay screen.
Purpose
The Power Meter is a troubleshooting tool, aimed at helping the installer quickly
verify and correct cabling and/or equipment problems. The Power Meter allows
you to connect a cable between equipment (or some other light source) and the
detector of the Fiber SmartProbe
can be saved to the tests database for later viewing.
Operation
From the Fiber Tools menu, press the Power Meter button. If the probe
inserted in the WireScope 350 has been calibrated (see Power Meter Calibration
below), the screen below on the right will appear. This is the Fiber Power Meter
tool. The Data Table shows a constantly updating power level while indicating
the wavelength of the inserted Fiber SmartProbe
The tool allows you to store the current power level as a reference by pressing
the Set Reference button. Once the reference is stored, the Delta field is
constantly updated to reflect the difference between the Reference value and the
current power level. This will provide a valid Delta field that shows a constantly
updating difference. The Save button allows you to save the current values in
the Data Table for later viewing. The Calibrate button brings up the Power
Meter Calibration screen described below.
+
, then measure the power level. The results
+
.
to
Test Setup
Data Table
Fiber Tools 106
Advertisement
Table of Contents
